Reliability Analysis on Ultimate Bearing Capacity of SteelReinforced HighStrength Concrete Filled Steel Tubular Slender Columns

XIAO Alin; HE Yibin; GUO Jian; HUANG Pin

doi:10.11835/j.issn.1674-4764.2009.05.006

您当前的位置：

首页 >

文章列表页 >

Reliability Analysis on Ultimate Bearing Capacity of SteelReinforced HighStrength Concrete Filled Steel Tubular Slender Columns

更新时间：2023-11-28

- Reliability Analysis on Ultimate Bearing Capacity of SteelReinforced HighStrength Concrete Filled Steel Tubular Slender Columns
- Journal of Civil and Environmental Engineering Vol. 31, Issue 5, Pages: 31-37(2009)
- 作者机构：
  
  湖南大学土木工程学院,湖南,长沙,410082
- 作者简介：
- 基金信息：
- DOI：10.11835/j.issn.1674-4764.2009.05.006
  CLC：
- Published：2009
- 稿件说明：
移动端阅览
XIAO Alin, HE Yibin, GUO Jian, et al. Reliability Analysis on Ultimate Bearing Capacity of SteelReinforced HighStrength Concrete Filled Steel Tubular Slender Columns[J]. Journal of Civil and Environmental Engineering, 2009, 31(5): 31-37.
DOI：

XIAO Alin, HE Yibin, GUO Jian, et al. Reliability Analysis on Ultimate Bearing Capacity of SteelReinforced HighStrength Concrete Filled Steel Tubular Slender Columns[J]. Journal of Civil and Environmental Engineering, 2009, 31(5): 31-37. DOI： 10.11835/j.issn.1674-4764.2009.05.006.

摘要

基于《建筑结构可靠度设计统一标准》(GB500682001)，利用一次二阶矩法（JC法）对钢骨〖XC半字线.tif

JZ〗钢管高强混凝土轴压长柱的极限承载力进行了可靠度分析，研究了可变荷载组合类型、荷载效应比、混凝土强度等级、钢管壁厚、钢骨截面面积、钢材屈服强度及长细比对组合柱承载力可靠指标的影响。分析结果表明，在工程常用长细比范围内，各公式的可靠指标均能满足规范对延性构件可靠度指标的要求；在所研究参数范围内，长柱的可靠度指标随荷载组合和荷载效应比的变化而变化，随混凝土强度等级的提高而增大，随钢管壁厚的增加而有所降低，钢骨截面面积对长柱的可靠指标无明显影响，同时，钢材屈服强度和长细比对各公式可靠指标的影响各不相同。

Abstract

The first degree second order moment method (JC method) recommended in Unified Standard for Reliability Design of Building Structures (GB500682001) was applied to analyze the reliability of steelreinforced highstrength concrete filled steel tubular slender columns. Several performances were studies

which were the influences of different load combinations

specific values of loads

strength grades of concrete

thickness of steel tube

area of crosssection of structural steel

steel yield strength and slenderness ratio on the reliability of the composite column. It was found that

when the slenderness ratios were within common range

the reliability indexes of the proposed formulae satisfied the demand of GB500682001 for plastic material on the whole. And it was concluded that the reliability index varied with the load combination and specific value of loads. The reliability index increased with the increase of concrete strength grade and decreased with the increase of steel tube thickness. Furthermore

steel yield strength and slenderness ratio had different influences on the reliability indexes.

关键词

Keywords

references

Views

770

下载量

CSCD

Alert me when the article has been cited

提交

Tools

Publicity Resources

No data

Related Author

No data

Related Institution

No data

AI问答

Address：Journals Department, Chongqing University, 174 Shazhengjie, Chongqing 400044, P.R.China Postal code：400044
Tel：+86-23-65111322 Email：xuebao@cqu.edu.cn
Technical support is provided by Beijing Founder electronics co., LTD 京ICP备09064830号-19 京公网安备11010802024621
It is recommended to read the content of this site in Chrome&IE9+. Please switch to extreme mode in browser 360.
Cookies We use cookies to help provide and enhance our service and tailor content. By continuing, you agree to the use of cookies.

⁰