Preparation of Polyferric Silicate Sulfate(PFSS)from Tetraethylorthosilicate and Its Algae Removal Performance

ZHENG Huaili; XIE Liguo; GAO Xu; TAN Hongfang; YANG Bo; JI Fangying

doi:10.11835/j.issn.1674-4764.2009.06.018

您当前的位置：

首页 >

文章列表页 >

Preparation of Polyferric Silicate Sulfate(PFSS)from Tetraethylorthosilicate and Its Algae Removal Performance

更新时间：2023-11-28

- Preparation of Polyferric Silicate Sulfate(PFSS)from Tetraethylorthosilicate and Its Algae Removal Performance
- Journal of Civil and Environmental Engineering Vol. 31, Issue 6, Pages: 102-106(2009)
- 作者机构：
  
  重庆大学三峡库区生态环境教育部重点实验室,重庆,400045
- 作者简介：
- 基金信息：
- DOI：10.11835/j.issn.1674-4764.2009.06.018
  CLC：
- Published：2009
- 稿件说明：
移动端阅览
ZHENG Huaili, XIE Liguo, GAO Xu, et al. Preparation of Polyferric Silicate Sulfate(PFSS)from Tetraethylorthosilicate and Its Algae Removal Performance[J]. Journal of Civil and Environmental Engineering, 2009, 31(6): 102-106.
DOI：

ZHENG Huaili, XIE Liguo, GAO Xu, et al. Preparation of Polyferric Silicate Sulfate(PFSS)from Tetraethylorthosilicate and Its Algae Removal Performance[J]. Journal of Civil and Environmental Engineering, 2009, 31(6): 102-106. DOI： 10.11835/j.issn.1674-4764.2009.06.018.

摘要

采用正硅酸乙酯(TEOS)代替传统的硅酸钠制备活性硅酸，将活性硅酸与聚合硫酸铁反应合成聚硅硫酸铁混凝剂，并研究了相关机理。由于正硅酸乙酯水解很缓慢，容易控制，可以得到重现性好的产物，有利于进行除藻性能的研究。通过正交实验等研究获得了聚硅硫酸铁的优化合成条件，即铁硅摩尔比为1.0，反应温度为50 ℃和反应时间为60 min。论文还研究了优化条件下合成的聚硅硫酸铁混凝剂除藻性能，得到除藻优化条件，即原水的pH值为11.0、预氧化剂的投加量为0.70 mg/L、聚硅硫酸铁的投加量为24.1 mg/L。

Abstract

Polyferric silicate sulfate flocculants were prepared by using tetraethylorthosilicate and polyferric sulfate as raw materials. The relevant mechanism was studied. And it was found that since tetraethylorthosilicate had the characteristics of slow hydrolyzation

the reaction was easy to control. Thus

the products had a good repeatability

which was better for the study of algae removal. The optimum preparation conditions of polyferric silicate sulfate were determined by using orthogonal design

in which Fe/SiO2 mole ratio was 1

polymeric temperature was 50 ℃ and polymeric time was 60 minutes. Furthermore

the optimum conditions of removals algae were determined as well

in which when the pH of raw waste water was 11.0

the dosage of PFSS prepared in the optimum condition was 24.1mg/L and the dosage of preoxidation was 0.7mg/L.

关键词

Keywords

references

Views

1054

下载量

CSCD

Alert me when the article has been cited

提交

Tools

Publicity Resources

No data

Related Author

No data

Related Institution

No data

AI问答

Address：Journals Department, Chongqing University, 174 Shazhengjie, Chongqing 400044, P.R.China Postal code：400044
Tel：+86-23-65111322 Email：xuebao@cqu.edu.cn
Technical support is provided by Beijing Founder electronics co., LTD 京ICP备09064830号-19 京公网安备11010802024621
It is recommended to read the content of this site in Chrome&IE9+. Please switch to extreme mode in browser 360.
Cookies We use cookies to help provide and enhance our service and tailor content. By continuing, you agree to the use of cookies.

⁰